#1 Appliance Repair in Arlington, VA
Appliance repair and installation for Arlington homes: refrigerators, washers, dryers, ovens, dishwashers, and built in appliances, with published price ranges up front and a written figure before any work begins.
Your recent projects →At Arlington Appliance Repair Co, we repair refrigerators, ovens, ranges, washers, dryers, and dishwashers for homeowners in Arlington, VA. The calls repeat because the machines do: a fridge warming up overnight, a washer stopped mid cycle. This page describes how the work is done.
Arlington runs from high rise corridors in Rosslyn, Ballston, and Crystal City to single family neighborhoods in Cherrydale, Westover, and Aurora Highlands, and the appliance stock follows that split exactly. Machines installed in the same building wave age in step, which is why whole streets seem to need the same repairs in the same seasons.
Our pattern does not change with the appliance: diagnose before quoting, publish the price band before the visit, and put the final figure in writing before work begins.
The menu below is the whole trade as households actually use it: the cooling, cooking, and laundry machines, the specialty units around them, and installation done to the same standard as repair. Arlington households plan on real figures, and this page exists so they can.
When the fresh food side runs warm, airflow is the first suspect: an evaporator fan that quit, a damper door stuck closed, or condenser coils blanketed in dust and pet hair. Households in Arlington book it through the form below: evidence first, one figure, then the fix.
Steady temperature error is the friendliest oven fault: a drifting sensor or a control that needs calibration, verified with a thermometer across three test cycles. In Arlington, the diagnosis names the part before the price is named.
Standing water and a humming pump is the most common washer call in the trade: a failed pump, or something small and cloth stopping it cold. The service page carries the full fault list and the cost band for Arlington homes.
Tumbling with cold air is the classic electric dryer pattern: an open heating element or a tripped thermal fuse, both confirmed with a continuity meter. In Arlington, that fault is diagnosed before it is quoted.
Standing water at the end of a cycle is the most common call, and the drain pump is the first suspect, followed by a clogged filter or a drain hose blocked where it meets the sink plumbing. In Arlington, it is diagnosed the way every service here is: tested first, quoted in writing, then repaired.
Freezers that run warm by a few degrees are failing the way that costs most: food thaws at the edges and refreezes, and the damage is done before anyone notices. In Arlington, it is quoted in writing after the machine is tested.
Gas zones fail at ignition or at flame quality: electrodes, switches, and ports for the first; clogged or corroded burner heads for the second. It is core work in Arlington, quoted from the published band after a real diagnosis, never from the symptom alone.
A call from Clarendon: French door refrigerator warming up over a weekend. Testing found the evaporator fan motor had failed and frost had bridged the air channels. We replaced the fan motor, cleared the frost, and verified cabinet temperatures over a full cooling cycle. County water hardness writes scale into heating elements and inlet valves here on schedule.
A call from Ballston: Panel ready door sagging and frosting the cabinet edge. Testing found hinge wear letting the door drop and break its seal line. We renewed the hinge hardware, realigned the panel, and verified the gasket seal around the full perimeter. Arlington splits between high rise corridors and single family streets, and the diagnosis starts by knowing which building we are in.
A call from Rosslyn: Top load washer stopping full of water. Testing found a baby sock wound through the drain pump impeller. We cleared the pump, tested it under load, and ran a full cycle to confirm clean drainage. Cherrydale, Westover, and Aurora Highlands owners keep machines long and repair deliberately.
Working kitchens in Arlington cannot wait politely, so commercial refrigeration is scheduled by stakes: product first, then the repair, documented for whoever approves the invoice.
Laundry serving tenants, guests, and clients in Arlington wears on a schedule rather than by surprise. We repair the machines and report the fleet's condition in writing, per unit, so owners can plan instead of react.
Light commercial cooking in Arlington, the ranges and ovens of its cafes, church kitchens, and small restaurants, is serviced in its honest category: tested with thermometers, quoted in writing, and returned to service with readings recorded.
Rental turnovers and tenant calls across Arlington are handled with written diagnoses and one figure per job, coordinated with tenants when the manager prefers, and invoiced per unit for clean records.
Every job follows the same order: listen to the symptom, test the machine, name the fault with evidence, quote one figure in writing, then repair and prove the repair under load. A quote written before the test is a guess with a dollar sign, and a repair without a proof cycle is a promise instead of a result. The proof, anywhere in Arlington, is a machine running its real work before we leave.
Parts are matched to the machine by model and specification, and wear parts like hoses, lines, and seals are renewed rather than reused when a job opens them up. Where a component has a known better revision, that is what gets fitted, and the old part is available for you to see. In Arlington, tested first and quoted in writing is simply the sequence.
Most common repairs finish in a single visit once the part is in hand. Diagnosis comes first at the published visit range, credited toward the repair when you proceed; the figure you approve is the figure for the work described, and a second fault revealed mid repair is reported before it costs anything. The method does not change between the corridors and the quiet streets.
Recent work in Arlington neighborhoods, each card with the repair, the place, and the final cost.
In Ballston, a dishwasher that had stopped draining traced to a tired pump and a hose sagging at the sink. Both were corrected, and the machine drained clean through two cycles.
A dryer in Crystal City ran hot and slow. The element tested weak and the first vent bend was packed; with both addressed, a timed load dried in a single cycle.
The Shirlington call was a range that lit slowly and heated slower. A weak igniter was the cause, replaced and timed across a full preheat.
A garage freezer in Lyon Park was losing ground in the heat. Dirty coils and a tired gasket shared the blame; cleaned and renewed, it held zero through a hot afternoon.
In Ballston, a glass top zone quit mid cooking. The element tested open; a new one was fitted and the surface reseated properly.
The Crystal City washer stopped with water standing. A jammed pump, cleared and tested, and the machine finished the load it had abandoned.
Repair pricing is published here because it should be: the national guides put the average appliance repair near $179, most jobs between $108 and $251, and the categories below show how the work is banded. Your figure is written after diagnosis, every time. That standard holds from Rosslyn to Shirlington, tower and single family alike.
The national guides average appliance repair at about $179, and most jobs fall between $108 and $251. The low end is wear parts and short visits; the top of the range is where cooling systems, boards, and deep access live. Averages set expectations, then the diagnostic visit prices your actual machine. No pressure, no mystery pricing, no parts on suspicion: the Arlington bargain.
By category, the guides put refrigeration near $255 on average, cooking near $214, and laundry near $184. The spread tracks the systems involved: sealed refrigeration at one end, belts and pumps at the other, with cooking's igniters and elements in between. Your appliance's band is published on its service page. The proof, anywhere in Arlington, is a machine running its real work before we leave.
A diagnostic visit commonly runs $75 to $125 in the published figures, usually credited toward the repair when work goes ahead. The visit finds the real answer, since one symptom like a warm refrigerator can trace to half a dozen parts. Proper testing first protects you from paying for the wrong repair, and if a machine is not worth repairing, you still leave with a clear finding and its reason. No pressure, no mystery pricing, no parts on suspicion: the Arlington bargain.
Four things move a repair figure: the part, the access, the machine's age, and the platform it belongs to. Labor follows the depth of the machine the part lives in, and parts follow the manufacturer's pricing for that class. The diagnostic visit exists to put all four on the table before you are quoted. Arlington households plan on real figures, and this page exists so they can.
The base is Arlington, and the working ground extends across the communities below: same crew, same standards, same published pricing. The areas: Clarendon, Ballston, Rosslyn, Crystal City, Pentagon City, Shirlington, Cherrydale, Lyon Park, Bluemont, Glencarlyn.
Also covered: Aurora Highlands, Westover, Lee Heights, Alexandria, Falls Church, McLean, Annandale, Fairfax, Vienna, Bailey's Crossroads. Each community has its own page with services, costs, and a recent project.
Tell us the appliance and the symptom on the form and we will answer with the published range and the next step.
The published national average is about $179 per job, with most repairs between $108 and $251. Refrigeration averages near $255, cooking near $214, and laundry near $184. Your job gets one written figure after diagnosis, and the diagnostic visit at $75 to $125 is credited toward the repair. In Arlington, tested first and quoted in writing is simply the sequence.
Repairs that replace a wear part on a sound machine are the value core of this trade. Repairs that rebuild a dying system are where we slow down and do the arithmetic with you. The method does not change between the corridors and the quiet streets.
We service the major brands sold in this region across kitchen and laundry, and most of the faults on this page are shared across brands because the underlying systems are shared. Tell us the brand and model on the form and we will confirm before the visit. That standard holds from Rosslyn to Shirlington, tower and single family alike.
Testing, in the machine's own order: codes read, temperatures and currents measured, suspect parts proven individually. Then the verdict in writing, the figure for the fix, and the choice left with you. Arlington households plan on real figures, and this page exists so they can.
Tell us your name, phone, email, service address, whether the job is a repair or an installation, and what the appliance is doing. We read every request and respond with the published range and the next step, a diagnostic visit that turns the range into one written figure. The method does not change between the corridors and the quiet streets.
Often, yes: older machines were built with serviceable parts, and a wear part repair on a sound cabinet buys years at a fraction of replacement. The diagnostic visit weighs condition and parts availability and gives you the arithmetic in writing. In Arlington, tested first and quoted in writing is simply the sequence.
Michael Donovan, Owner and Lead Technician
I'm Michael Donovan, owner of Arlington Appliance Repair Co, and I read every quote request that comes in myself. No call center sorts it first, and no one quotes a repair off a phone description alone. I start with diagnosis, because a refrigerator that stops cooling or a washer that stops draining can have more than one cause, and the right repair depends on finding the actual one. That first step shapes everything that follows: an honest look at the fault, what it will take to fix it, and whether fixing it makes sense for your home.
The price bands on this site come from published national guides, and I label them as such because they are a starting point, not a promise pulled from thin air. Your diagnostic visit is what turns that band into one written figure for your specific appliance, your model, and the fault I confirmed in person. Once you approve that figure, that is the final figure. I do not add surprises after the work starts, and I do not start any work until you have seen the number in writing and said yes to it yourself.
I will also tell you plainly when replacement beats repair. If an appliance is near the end of its useful life, or the repair costs more than the machine is worth, I say so directly and explain why. I know Arlington housing well, from the high rise corridors in Rosslyn, Ballston, and Crystal City to single family neighborhoods in Cherrydale, Westover, and Aurora Highlands, and that matters because access, parking, elevators, and tight laundry closets change how a job should be planned. My job is a clear answer you can trust, whichever way it points.
The shortest path to a working appliance runs through this form: the machine, the symptom, and your address. From there we respond with the published band for the work and arrange the visit that proves the fault before anyone quotes a repair.
Prefer to talk it through first? Send the form and we will call you back at the number you give us.